Routing

CONFIGURE > SERVICES > Routing

The Console Manager supports Static Routing and Dynamic Routing. Static Routing is currently configured via the ogcli interface, while Dynamic Routing is configured via the UI.

Dynamic Routing

To enable Dynamic Routing on the CM, navigate to the CONFIGURE > SERVICES > Routing page.

Dynamic Routing supports four routing protocols, these are:

• BGP (Border Gateway Protocol)

• OSPF (Open Shortest Path First Protocol) (see Routing later in this topic).

• IS-IS (Intermediate System to System Protocol)

• RIPD (Routing Information Protocol)

Select the preferred routing protocol then click Apply.

Note:If no protocol is selected, no route sharing services are run on the CM.

Static Routing (via the ogcli)

To enable Static Routing on the CM, open an ogcli terminal by navigating to ACCESS > Local Terminal.

Static Routing ogcli Help

For Help on implementing a Static Route protocol via ogcli, enter the command:

ogcli help static_routes

Create Static Route - Example:

ogcli create static_route << 'END'
destination_address="10.1.45.0"
destination_netmask=24
gateway_address="192.168.1.1"
interface="system_net_physifs-1"
metric=100
END

Static Routing Arguments

Argument	Description
get	Get a list of static routes.
create	Add a static route.
replace	Similar to the "Create Static Route" example given on the previous page. Creates a single static route by specifying its UUID; or a list of static routes. Overwrites existing routes.
delete	Delete all static routes.
merge	Merge the existing configuration list with a new list.