Loading Lighthouse

This section describes the initial setup stages for a new Lighthouse VM, from login, to setting external addresses, to setting the clock.

To load Lighthouse

  1. Open a new browser window or tab, then enter one of the following:

https://192.168.0.1/

https://[DHCP-supplied address]/

or an IPv6 address, for example:

https://[fe80::a00:27ff:fe39:daa3/64].

  1. Press Return. The Lighthouse Login page loads. A warning message displays because of the default self- signed certificate. You can ignore this at first load, and later install your own valid certificate using SETTINGS > SERVICES >HTTPS Certificate to remove the warning message.