Push Templates

Users with Lighthouse Administrator privileges (that is, users with the Lighthouse Administrator role or users who are members of groups with the Lighthouse Administrator role) can access Node TOOLS > Config Templates and push templates affecting nodes in node filters linked to their role.

The following types of templates can be applied to selected nodes:

  • Authentication

  • Users and Groups

  • Script

  • Netops Module Activation

  • Port Logging

  • Smart Management Fabric

Lighthouse Administrators can manually apply the Netops modules of Secure Provisioning, Automation Gateway, or IP Access to the suitable Opengear Console Server node.

Push a Template

The process to push templates consists of four stages, each one a step in the overall wizard:

  1. Select a template.

  2. Select the target nodes.

  3. Run the Pre-flight Test. This test run simulates what happens if the template is pushed to the selected nodes.

  4. Push the template.

Select a Template

  1. Select Node Tools > Config Templates.
    The CONFIG TEMPLATES page displays.

  2. Select a template config type tab:

    • AUTHENTICATION
    • NETOPS MODULES
    • PORT LOGGING
    • SCRIPT
    • SMART MANAGEMENT FABRIC
    • USERS AND GROUPS

  3. For the required template click the Push template icon on the right of the row.
    The PUSHING TEMPLATE page displays.

Select the Target Nodes

  1. Select the target nodes by clicking the check boxes next to them.

    Note:  Third-party nodes are not supported for template execution.

Run Pre-Flight Test

  1. Click Run Pre-Flight Test.
    After all nodes finish pre-flight, the Pre-flight Status goes green and the Push Configuration button becomes active.

Push the Template

  1. Click Push Configuration.
  2. Confirm the TEMPLATE RUN STATUS per node as displayed in the column.
  3. Confirm the PUSH STATUS per node as displayed in the column.
  4. Click Exit to Config Templates.