Examine or Change Lighthouse VPN Network Settings

The VPN network ranges for Lighthouse VPN (LHVPN) and Smart Management Fabric can be set up or modified.

To setup the Lighthouse VPN:

1. Select > SERVICES > Lighthouse VPN.

2. Under the VPN NETWORK RANGE section:

   1. Enter the Address Space: The range to be used for the VPN.

      Note: The Address Space must be in the IPv4 Private Address Space, subnet must have enough space for the existing Enrolled Nodes to Lighthouse, cannot overlap with an existing subnet across lighthouse and the base address for the network range.

   2. Enter the CIDR Subnet Mask: The Classless Inter-Domain Routing notation for the subnet mask for the VPN network.
   3. Calculated Node Capacity: An auto-calculated field with the total number of usable nodes.

   4. Enter the Tunnel MTU: The MTU is the size, in bytes, of the largest packet supported by a network layer protocol, including both headers and data.

3. Under the SMART MANAGEMENT FABRIC NETWORK RANGE section:

   1. Enter the Address Space.
   2. Enter CIDR Subnet Mask.
   3. Calculated Node Capacity: An auto-calculated field with the total number of usable nodes.
   4. Smart Management Fabric MTU: an auto-calculated field, the Smart Management Fabric MTU is based on a fixed offset off the LHVPN MTU.