Disable NetOps Modules via Template

If NetOps is uninstalled, the nodes may continue to run NetOps modules and we recommend a node clean up.

Notes:
  • The availability of these templates is dependent on your subscription type.
  • Clean up templates only work on Opengear devices.
  • If you are cleaning up the nodes due to the installation of a subscription, it is recommended to perform the clean up BEFORE you apply the subscription so that you can identify the nodes running NetOps before NetOps is disabled.

Identify nodes running netOps

IMPORTANT: If you have already deactivated NetOps (via subscription installation or otherwise) prior to identifying the nodes running NetOps, then this filter is not available and you can no longer identify the nodes.

  1. In the Menu Pane, select Nodes.
    The NODES page displays with the ENROLLED tab selected.

  2. Click the Filter Nodes drop-down and select New Node Filter.
    The filter criteria section displays.

  3. From the Field to search, select NETOPS > Module.

  4. From the Value drop-down, select the appropriate NetOps module from Automation gateway, IP Access, or Secure Provisioning.

  5. To include multiple NetOps modules, click Add Criteria and repeat steps 3 and 4 for any additional NetOps modules.

  6. Click Apply.
    The list of nodes updates to display only nodes running the selected NetOps modules.

Clean up nodes and disable NetOps

  1. In the Menu Pane, select Node Tools > Config Templates.
    The CONFIG TEMPLATES page displays with the AUTHENTICATION tab selected.

  2. Select the NETOPS MODULES tab.
    The available templates display.

  3. For the following templates, click the Push template icon on the right of the row:

    • Disable Secure Provisioning: to disable Secure Provisioning if present on the selected node(s).

    • Disable IP Access: to disable IP Access if present on the selected node(s).

    • Disable Automation Gateway: to disable Automation Gateway if present on the selected node(s).

    The PUSHING TEMPLATE  page displays.

    Note: This page automatically has a filter applied to display only nodes with the selected NetOps module. You can remove the filter if required and display all enrolled nodes.

  4. Select the check boxes next to the required nodes.

  5. Click Run Pre-Flight Test.
    The test status is displayed in the PREFLIGHTSTATUS column for the node.

  6. When pre-flight is complete, click Push Configuration.
    The templates connect to the selected nodes and remove docker entries associated with the module and call the deactivate NOM endpoint.