Manually Apply NetOps Modules via Template

Note: The availability of these templates is dependent on your subscription type.

1. In the Menu Pane, select Node Tools > Config Templates.
   The CONFIG TEMPLATES page displays.
   

2. Select the NETOPS MODULES tab.
   The available templates display.

3. For the following templates, click the Push template icon on the right of the row:

   • Secure Provisioning: to apply Secure Provisioning to the selected nodes.

   • IP Access: to apply IP Access to the selected nodes.

   • Automation Gateway: to apply Automation Gateway to the selected nodes.

   The PUSHING TEMPLATE  page displays.

4. Select the check boxes next to the required nodes.

   Note:  Only applicable Console Servers for the module display during this node selection step.

5. Click Run Pre-Flight Test.
   The test status is displayed in the PREFLIGHTSTATUS column for the node.

6. When pre-flight is complete, click Push Configuration.