SNMP Manager Settings

To enable SNMP Manager:

  1. In the Settings Pane, select > SERVICES > Alerting and Monitoring.
    The ALERTING AND MONITORING page displays with the SNMP MANAGER tab selected.

  2. Select Enabled to enable the SNMP Manager.

  3. Select one of the following to set the Manager Protocol: UDP, UDP over IPv6, TCP, or TCP over IPv6.

  4. Enter the Manager Address to receive SNMP messages.

  5. Enter the Manager Port: the TCP/UDP port number to send SNMP messages to.

  6. Select one of the following for the the SNMP protocol Version: v1, v2c, or v3.
    Additional fields display depending on the version selected.

  7. Complete the following actions depending on the selected SNMP protocol Version:

    • If you selected v1, enter the SNMP Community to use for messages.

    • If you selected v2c:

      1. Set the SNMP Message Type to TRAP or INFORM.

      2. Enter the SNMP Community to use for messages.

    • If you selected v3:

      1. Set the SNMP Message Type to TRAP or INFORM.

      2. Optional: If you select TRAP for the SNMP Message Type, specify an Engine ID for sending an SNMP TRAP message.

        Note: If the Engine ID is left blank, the auto-generated Engine ID from the SNMP Service is used. An Engine ID is not required for an SNMP INFORM message.

      3. Enter the SNMP v3 Engine ID and required Configure SNMP Manager Settings.

      4. Enter the Username to send the messages as.

      5. Set the Authentication Protocol to MD5 or SHA.

      6. Enter the Authentication Password for the SNMP user.

      7. Set the Privacy Protocol to DES or AES.

      8. Enter a Privacy Password.

  8. Under SNMP Message Settings, set the events to trigger a TRAP/INFORM notification by checking a combination of:

    • Node Connection Status: send an SNMP notification when a node connects or disconnects.

    • Secondary Replication Status: send an SNMP notification when problems occurs with database replication on secondary Lighthouse.

    • Node Cellular Health Status: to use Cellular Health Status change traps.

  9. Click Apply.

For information on the structure of notifications for Opengear nodes, refer to OG-LIGHTHOUSE-MIB.mib.