Cellular Health Reporting

Administrative users can control the cellular health reporting settings under > SERVICES > Cell Health Reporting.

When cell health checks are enabled, the network carrier, IMEI, IMSI, and ICCID of the downstream SIM being utilized are part of the information that is displayed in Lighthouse for managed nodes.

If a managed node has the modem disabled/off, the appropriate status is shown in Lighthouse for the node.

Enable Cell Health Reporting

To enable Cell Health Reporting:

1. In the Settings Pane, select > SERVICES > Cell Health Reporting.
   The CELL HEALTH REPORTING page displays.

2. Select Enabled.
   The fields to configure cell health reporting display.

3. Set the Signal Quality Ranges to report.
   Click and drag the range handles to the range value corresponding to: Bad, Moderate, and Good.

4. Set the Frequency for Lighthouse to check the signal quality.

5. If you want to enable the cell connectivity test to get a complete cell health report, select the Cell Connectivity Test check box.

   Note:  This causes cell data consumption.
   

6. Click Apply.