Local Management Consoles

Note:Applies to OM2200 Devices only. Not applicable to OM1200.

CONFIGURE > Local Management Consoles

This feature allows administrators to log in and configure the OM via the RJ-45 or USB ports on the device. You can edit settings or disable the local RJ45 serial console (Cisco straight -X2 pinout) and the USB serial console (needs user supplied micro-USB to USB-A cable).

To edit the settings of a local management console:

  1. Navigate to CONFIGURE > Local Management Consoles. Here you'll see a list of consoles.

  2. Locate the console you want to manage, then, click on the Edit Management Console Port button (pencil icon) under Actions.

  1. On the Edit Local Management Console page you can set the parameters for:

    • Baud Rate

    • Data Bits

    • Parity

    • Stop Bits

    • Terminal Emulation

    • Enable or disable Kernel Debug Messages

    • Enable or disable the selected Management Console

 

Note:Enabling Kernel Debug Messages can only be applied to a single serial management console.

To disable a local management console:

  1. Click CONFIGURE > Local Management Consoles.

  2. Click on the Disable Management Console Port button under Actions next to the console you wish to disable.