System Alerts

Tip: For more detailed information about configuring SNMP Alerts, see the individual topic pages that follow.

You can add or delete System Alert Managers under Configure > System Alerts for the following:

• System Alerts - General: Covers notification for the following:

  • Configuration Change: For changes that occur to the system configuration.

• System Alerts - Power: When voltage SNMP alerts are enabled, network operators are immediately notified should the PSU begin operating outside design tolerances.

• System Alerts - Temperature: When system temperature alerts are enabled, network operators are immediately notified should the system begin operating outside user-defined tolerances.

• System Alerts - Networking (Connection Status) (Cell Signal Strength): Be notified when cell signal strength leaves or re-enters the selected range, or when the network link state changes. A slider adjusts the upper and lower signal strength.