Create a Static Route

On the Static Routes page, you can add static routes.

Note: Only basic validation is performed when static routes are saved. Check the status column to ensure your route is installed and working correctly.

1. Navigate to CONFIGURE > NETWORK CONNECTIONS > Static Routes.

2. Click the Add button to navigate to the creation page.

3. Enter a valid IPv4 or IPv6 destination address or network, followed by the netmask in CIDR notation.
   The destination address/network must be unique.

4. Enter the gateway or select an interface for the static route to use.

5. Optionally, provide a metric for the route. Routes with a lower metric value are higher priority.
   

   Destination Address	Default Metric
   IPv4	0
   IPv6	1024

6. Click the Apply button to save the changes.

7. If the changes are saved successfully you are returned to the Static Routes list page.

   • If there is an error with the configuration and the route fails to install, a red banner displays.

   • If the route installed successfully, a green success banner displays.

   The current status of the configured route displays in the table, which may change depending on the status of the network configuration.