Local Management Consoles

Note: Applies to OM2200 Devices only. Not applicable to OM1200.

This feature allows Administrators to log in and configure the OM via the RJ-45 or USB ports on the device. You can edit settings or disable the local RJ45 serial console (Cisco straight -X2 pinout) and the USB serial console (requires ).

Note: This requires a:
  • user supplied micro-USB to USB-A cable for the OM2200.
  • USB-C cable for the OM1300.

To edit the settings of a local management console:

  1. Navigate to CONFIGURE > Local Management Consoles.
    A list of consoles displays.

  2. Locate the console you want to manage, then under Actions, click on the Edit Management Console Port button (pencil icon).

  1. On the Edit Local Management Console page, you can set the parameters for:

    • Baud Rate

    • Data Bits

    • Parity

    • Stop Bits

    • Terminal Emulation

    • Enable or disable Kernel Debug Messages

      Note: Enabling Kernel Debug Messages can only be applied to a single serial management console.

    • Enable or disable the selected Management Console

To disable a local management console:

  1. Click CONFIGURE > Local Management Consoles.

  2. Locate the console you want to disable, then under Actions, click on the Disable Management Console Port button.