System Alerts

Tip: For more detailed information about configuring SNMP Alerts see the individual topic pages that follow.

System Alert Managers can be added or deleted under Configure > System Alerts for the following:

• System Alerts - General: Covers notification for the following causes.

  • Authentication: Notifies when a user attempts to log in via SSH, REST API, Web GUI, or the device's serial ports. An alert is sent regardless of whether the log in has succeeded or failed.

  • Configuration Change: For changes that occur to the system configuration.

• System Alerts - Power: When voltage SNMP alerts are enabled, network operators are immediately notified should the PSU begin operating outside design tolerances.

• System Alerts - Temperature: When system temperature alerts are enabled, network operators are immediately notified should the system begin operating outside user-defined tolerances.

• System Alerts - Networking (Connection Status) (Cell Signal Strength): Be notified when cell signal strength leaves or re-enters the selected range, or when the network link state changes. A slider adjusts the upper and lower signal strength.

Tip: Manage the system settings on the CONFIGURE > System Alerts > System Alerts pages.